DIN Rail Dual 1×6 To Terminal Block Adapter

This one’s going out to all the makers and designers who use DIN railing in their builds. This adapter plate is perfect for simplifying complex power supply wiring. There’s two spring-terminal blocks on one side of the PCB, and a 2×6 set of connected blocks on the other. As you may expect, the positive marked terminal blocks are all connected together, as are the negative marked blocks.

Use stranded or solid-core wires, they can be signal or power wires. And of course you can fit a few wires per block so it isn’t just 1:1 wire connection.

No soldering required! Just push in the terminal block tabs and slide in your stranded or solid-core wire. DIN rail not included, of course.